Gate motors
Gate Motor Not Working? 10 Common Faults and Fixes
Gate won't open, stops halfway, beeps or ignores the remote? The 10 most common gate motor faults in Cape Town, what causes them and what you can check first.
By the CPT Installation team · · 3 min read
When the gate won't open you are either stuck inside or stuck outside, so it always feels urgent. Before calling anyone, a few checks can save a call-out. Here are the faults we see most often.
First, safety. If you need to get out, use the manual release. See how to open your gate manually.
1. Gate does nothing at all
Likely cause: flat or dead battery, tripped mains, blown fuse. Check: Is there power at the plug point? Are the motor's LEDs on? If the battery is more than two or three years old, it's probably the culprit. See gate motor batteries.
2. Gate works on mains, dies during load shedding
Likely cause: battery that no longer holds a charge, or a failed charger. Fix: replace the battery and test the charger output.
3. Remote doesn't work, but the gate opens with another remote
Likely cause: flat remote battery or lost code. Fix: replace the remote battery (usually a small coin or A23 cell) and recode it. See gate remote not working.
4. No remotes work at all
Likely cause: receiver fault, power issue or a controller that has lost its memory after a surge.
5. Gate opens, stops, then reverses
Likely cause: collision sensing. The motor thinks it hit something. Usually a dragging wheel, a stone in the track, a bent rack or wind on a solid gate. Check: switch to manual and push the gate by hand. If it's stiff, the gate needs attention, not the motor.
6. Gate won't close fully
Likely cause: safety beams blocked, misaligned or faulty. Check: clean the beam lenses and look for anything in the way, such as plants, spider webs or a bin.
7. Motor hums but gate doesn't move
Likely cause: manual release left disengaged, stripped gearbox, or rack not meshing with the pinion. Check: make sure the manual release is locked back in place.
8. Motor beeps constantly
Likely cause: a status warning such as mains failure, low battery or a fault code. Check: on Centurion motors, the LED flash pattern or display shows the fault. The manual lists the codes.
9. Gate opens by itself
Likely cause: a stuck remote button, a faulty trigger input (often an intercom or push button), or water in a trigger cable.
10. Motor missing or cover forced
Likely cause: theft. Unfortunately common. See anti-theft brackets.
When to call a technician
- Anything involving the controller card or gearbox
- Burning smells or visible damage
- Repeated faults after a battery change
- Gates that are hard to push by hand
We repair all major brands across Cape Town, with call-outs from R450. See gate motor repairs.