CCTV
Where to Place CCTV Cameras Around Your Home
CCTV placement that actually identifies intruders: heights, angles, the 8 spots every Cape Town home should cover and the mistakes that ruin footage.
By the CPT Installation team · · 3 min read
The most common problem we see on existing CCTV systems is not bad cameras. It is bad placement. Cameras mounted high under the eaves, pointing across the lawn, produce footage of the top of someone's head. Here is how to place cameras so the footage is actually useful.
The golden rules
- Cover the approach, not the object. Point cameras at the routes people take to reach the house, not at the car or the TV.
- Identify at choke points. Every entrance needs one camera close enough to capture a face.
- Mount lower than you think. Around 2.4–2.8 metres is ideal for identification. High enough to be out of easy reach, low enough to see under a cap.
- Avoid backlight. A camera facing the street from a dark porch will show silhouettes. Put it at an angle, or choose a camera with good wide dynamic range.
- Overlap. If someone disables one camera, another should see them do it.
The 8 spots to cover
1. The vehicle gate
Capture faces and number plates of anyone entering. Mount inside the property looking at the gate at an angle.
2. The gate motor
Gate motors and batteries are common targets. A camera on the motor side is cheap insurance. See anti-theft brackets.
3. The front door
An identification camera at head height covering the door and the path to it.
4. The driveway
A wider view that shows vehicles and people moving up the driveway.
5. Side passages
The most common route to the back of a house. A camera at each end of the passage, or one looking down its length.
6. The back boundary
Especially important for homes backing onto greenbelts, parks, rivers, rail lines or open ground, which is common in Constantia, Tokai and Meadowridge. Use AI line-crossing detection.
7. Garden doors and patio
Sliding doors are a favourite entry point.
8. The street (with care)
A view of vehicles arriving is useful, but keep neighbours' windows out of shot and use privacy masking. Read CCTV and POPIA.
Mistakes to avoid
- Cameras too high. You get roofs and hats.
- Too wide a view at the gate. A 2.8 mm lens across a 5 m gate won't identify anyone beyond a couple of metres. Use a 4 mm or varifocal lens.
- IR reflecting off walls. Keep infrared cameras away from nearby walls and eaves, or switch to colour night vision. See ColorVu vs infrared.
- Trees in frame. Moving branches trigger constant false alerts.
- Cables exposed. Cut cables kill cameras. Run them in conduit or inside the roof.
Special cases in Cape Town
- Steep plots in areas like Camps Bay or Fresnaye create blind spots between levels, so plan each terrace.
- Coastal homes need cameras mounted where salt spray is limited, with sealed connectors.
- Windy areas such as Table View need rigid, short mounts to stop image shake.
Want a placement plan for your home? Get a free CCTV quote.